about sim_intparam_dynamic_warning_disabled_mask
Posted: 16 Dec 2016, 03:17
Hi,
I try to disable some warning messages during simulation by calling simxSetIntegerParameter to set
the sim_intparam_dynamic_warning_disabled_mask before simxStartSimulation.
But find the value of this mask is automatically reset to 0 after the call simxStartSimulation.
I don't think it is an expected behavior since other values like sim_floatparam_simulation_time_step or
sim_boolparam_realtime_simulation keep their value well.
I use V-REP_PRO_EDU_V3_3_2_64_Linux version.
Thanks.
I try to disable some warning messages during simulation by calling simxSetIntegerParameter to set
the sim_intparam_dynamic_warning_disabled_mask before simxStartSimulation.
But find the value of this mask is automatically reset to 0 after the call simxStartSimulation.
I don't think it is an expected behavior since other values like sim_floatparam_simulation_time_step or
sim_boolparam_realtime_simulation keep their value well.
I use V-REP_PRO_EDU_V3_3_2_64_Linux version.
Thanks.