Page 1 of 1

Control a joint to cyclic rotate within the setup angles

Posted: 22 Feb 2018, 15:16
by el17al
I'm trying to limiting the rotation angle of my joint. I read a similar post, but the uploaded model has been removed. Here is the link: viewtopic.php?f=9&t=3041. I copied and pasted the code into a threaded script. The code could run but my model didn't follow my setup. In addition, I don't know how to write the ' initialization code ' and ' clean-up code' ?
Does anyone keen to help ? because i don' t have much programming experience.
Cheers!