Page 1 of 1

bolting the base

Posted: 13 Mar 2018, 20:56
by zoebhosain

how do I bolt the Base of the robot to the ground?

Secondly, My simulation works perfectly with pure shapes. the moment i add mass and other dynamic properties the programme loses its plot. Am i missing anything?

Re: bolting the base

Posted: 14 Mar 2018, 07:59
by coppelia

you need to set the base of the robot to static (i.e. non-dynamic).

If your robot is not stable, it could have many many reasons, specially if your robot is dynamically enabled. Make sure to carefully read this page.

Also, it could be helpful to post your scene, so that we can get an overview of what might be wrong.