Hi,
I have a dynamically enabled joint (force/torque mode) that uses the "default" PID control loop. However, I need to access the control variable (which I assume is a torque) to do some evaluations.
How do I read the control signal? Is it possible to add an external signal to it before it goes into actuation? For reference, I need to simulate actuator failure.
Thanks
Add disturbance on control signal
-
- Posts: 27
- Joined: 25 Apr 2017, 17:26
Re: Add disturbance on control signal
Hi, thanks for the reply. However, I still have doubts about it, what is the control variable? Assuming I want to track it on a graph, which data stream should I pick?
EDIT: I need to know specifically the torque exherted by the joint. Is it possible?
EDIT: I need to know specifically the torque exherted by the joint. Is it possible?